Engine Flywheel Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)

Special Tools

• EN-652:  Flywheel Holder
• EN-45059:  Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools .

1. Clean the thread in the crankshaft.
Fig 1: Flywheel And Flywheel Holder
Courtesy of GENERAL MOTORS CORP.
2. Install the flywheel (2).
3. Install the EN-652:  holder (1).
Fig 2: Flywheel And Bolts
Courtesy of GENERAL MOTORS CORP.
CAUTION: Refer to Fastener Caution .
4. Install the 6 NEW flywheel bolts (1, 2) and tighten the bolts in 3 passes using the EN-45059:  sensor kit :
   1. First pass to 35 N.m (26 lb ft) .
   2. Second pass to additional 30° .
   3. Third pass to an additional 15° .
5. Remove the EN-652:  holder.