LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 270 (Engine Mechanical - 1.8L (2H0 Or LUW) - Repair Instructions - Off Vehicle (2 Of 2)) >> Oil Pan Installation

Oil Pan Installation

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Joints For Sealant
    GM1944491Courtesy of GENERAL MOTORS CORP.
  1. Clean the sealing surfaces.
  2. Apply approximately a 3.5 mm (0.138 in) thick bead of oil pan sealant to the joints (arrows). Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended sealant.
    3. Fig 2: Sealant Application Area
    GM2189266Courtesy of GENERAL MOTORS CORP.
    NOTE: The assembly time, including torque check, must take no longer than 10 minutes.
  3. Apply approximately a 3.5 mm (0.138 in) thick bead of oil pan sealant (1) to the oil pan. Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended sealant.
    4. Fig 3: Oil Pan And Bolts
    GM2027008Courtesy of GENERAL MOTORS CORP.
  4. Install the oil pan (2).
  5. Install the 15 oil pan bolts (1).
    6. CAUTION: Refer to Fastener Caution
  6. Tighten the oil pan bolts on the cylinder block to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals