Special Tools

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

EN-45059: Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools .

Lubricate the piston rings, piston, inner cylinder bore surface and a piston ring compressor with clean engine oil.
Install the piston ring compressor in order to compress the piston rings.

Fig 1: Connecting Rod Assembly, Connecting Rod Bearing And Connecting Rod Cap

Courtesy of GENERAL MOTORS CORP.

Install the piston and connecting rod assembly (4).
Install the connecting rod bearing (3).
Install the connecting rod cap (1).

CAUTION: Refer to Fastener Caution .

Install the connecting rod bolts (2) and tighten to 35 N.m (26 lb ft) + 45° use the EN-45059: sensor kit.
Assemble the caps and connecting rods in the marked position.
Rotate the crankshaft to a position where the connecting rod bolts are in the best situation for install.