LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 270 (Engine Mechanical - 1.8L (2H0 Or LUW) - Repair Instructions - Off Vehicle (2 Of 2)) >> Camshaft Position Actuator Solenoid Valve Installation

Camshaft Position Actuator Solenoid Valve Installation

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Position Actuator Solenoid Valves, Bolts And Seals
    GM2028075Courtesy of GENERAL MOTORS CORP.
    NOTE: Lubricate the NEW camshaft position actuator solenoid valve seals with NEW engine oil. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  1. Install NEW camshaft position actuator solenoid valve seals (3).
  2. Install the camshaft position actuator solenoid valves (2).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the camshaft position actuator solenoid valve bolts (1) and tighten to 6 N.m (53 lb in).
scientia non olet · About LEMON Manuals