Section 53 (Springs - Removal, Replacement And Installation (644 Body))
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Replacing The Springs (2003-2004)
- Replacing the Rear Spring And Shock Absorber
- Notes
- Slacken Off the Upper Section Of the Rear Shock Absorber
- Remove the Mounting For the Anti-Roll Bar
- Remove the Rear Shock Absorber
- Compress the Spring
- Disassemble the Shock Absorber
- Reinstall the Coil Spring
- Assemble the Shock Absorber
- Check the Shock Absorber
- Install the Upper Section Of the Rear Shock Absorber
- Install the Lower Section Of the Rear Shock Absorber
- Install the Wheel
- Tighten the Lower Control Arm
- Spring Strut And Spring Front, Replacing
- Replacing the Rear Spring And Shock Absorber
- Replacing The Springs (2001-2002)
- Spring And Shock Absorber Rear, Replacing
- Notes
- Removing the Shock Absorber
- Removing the Mounting For the Anti-Roll Bar
- Assembling the Special Tool
- Compressing the Spring
- Disassembling the Shock Absorber And Spring
- Installing the Spring
- Assembling the Shock Absorber And Spring
- Checking the Shock Absorber
- Installing the Upper Mounting For the Shock Absorber
- Installing the Shock Absorber
- Installing Wheels
- Tightening the Lower Control Arm
- Spring Strut And Spring Front, Replacing
- Spring And Shock Absorber Rear, Replacing
- Suspension, Shock Absorbers And Anti-Roll Bar (2000)
- Anti-Roll Bar, Anti-Roll Bar Bushings. Replacement
- Removing And Installing the Anti-Rollbar Link
- Remove the Steering Gear Housing From the Steering Column
- Preparations
- Remove the Central Front-Rear Member
- Remove the Gear Selector Lever From the Transmission
- Remove the Front Exhaust Pipe From the Three-Way Catalytic Converter (TWC)
- Remove the Control Arms From the Anti-Roll Bar
- Remove the Cross Member
- Remove the Anti-Roll Bar From the Cross Member
- Install the Anti-Roll Bar On the Cross Member
- Install the Cross Member
- Secure the Control Arms On the Anti-Roll Bar
- Assemble the Front Exhaust Pipe And the Three-Way Catalytic Converter (TWC)
- Reinstall the Gear Selector Lever In the Transmission
- Install the Central Front-Rear Member
- Install the Steering Shaft On the Pinion Shaft
- Replace the Link
- Spring Strut And Spring Front, Replacing