Install the Cross Member
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Lift the cross member. Take the steering gear housing through the cross member.
Install the steering shaft on the pinion shaft.
Check that the markings correspond.
Secure the cross member in the bodywork.
the long screws at the front edge. Tighten to 108 Nm .
the short screws at the rear edge. Tighten to 88 Nm .