Section 117 (Clutch - Removal, Replacement And Installation (Coupe))
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Clutch (M56; 1998-2002)
- Checking And Replacing The Throwout Bearing
- Checking And/Or Replacing The Clutch And Clutch Driven Plate
- Notes
- Removal
- Blocking the flywheel
- Aligning the counterhold for automatic clutch adjustment
- Installing the Compression Tool
- Relieving the Load From The Clutch Diaphragm Spring
- Checking the Clutch
- Checking the Pressure Plate For Out-Of-True
- Checking the Clutch Driven Plate
- Checking That There Are No Cracks Or Large Scratches On the Flywheel
- Installation
- Clutch Pedal, Replacement
- Replacing the Clutch Master Cylinder
- Clutch Pedal, Replacing Auxiliary Spring (B5234T3, M56; 1998)
- New Clutch For Turbo Engine (B5234T3, M56; 1998)
- New Clutch Control And New Clutch Introduced On C70/S70/V70. New Clutch Only Applies To The Following Engines: B5204T3, B5234TX and B5254T
- Notes
- A New Self-Adjusting Clutch With Code SAC (Self Adjusting Clutch) And A Concentric Placed Throwout Bearing With Integrated Hydraulic Clutch Slave Cylinder Introduced In Week 20 1997
- Replacing Clutch
- Removing Clutch Slave Cylinder
- Checking Clutch Slave Cylinder And Throwout Bearing
- Replacing clutch slave cylinder
- Install Adapter And Rubber Seal
- Removal of clutch
- Installing tool
- Lock flywheel
- Compress clutch
- Remove Clutch
- Check Clutch
- Check the Clutch For Distortion
- Check Clutch Driven Plate
- Install Clutch
- Install Clutch Driven Plate And Center
- Replacing New Clutch
- Remove Tools
- Install Transmission
- Check and Test Driving
- New Clutch Control And New Clutch Introduced On C70/S70/V70. New Clutch Only Applies To The Following Engines: B5204T3, B5234TX and B5254T
- New Clutch For Turbo Engine (B5254T, M56; 1998)
- Transmission, Removal (B5234T3, M56; B5254T, M56; 1998)
- Transmission, Removal
- Notes
- Set Steering Wheel Position
- Remove
- Turbo Models Only
- Slacken the Nut On the Rear Engine Mounting/Splashguard a Few Turns.
- Disconnect Hoses From Control Valve (A)
- Install
- RH Drive Cars Only
- Disconnect RH Driveshaft
- Remove Bolts From Front Engine Mounting Subframe
- Disconnect Subframe From Car
- Lower Subframe
- Hang Steering Gear On Left-Hand Side Using Hook 9995045 In Hole In Frame Member Flange
- Tape Driveshaft End To Oil Pipe
- Remove Left-Hand Driveshaft
- Lower Engine And Transmission
- Install Universal Tool 9995972 And Transmission Fixture 9995463 On Jack
- Remove Remaining Bolts Holding Transmission To Engine (7)
- Remove Transmission
- Transmission, Removal