Removing Clutch Slave Cylinder
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Remove bell housing rubber seal and feed it into pipe towards clutch slave cylinder.
- Pull out the striker plate that locks the pipe to the quick release connector to the adapter.
- Reinstall locking tongue in adapter.
- Remove adapter. Keep the adapter in a plastic bag to make sure it is clean.
- Remove the two screws.
- Lift out clutch cylinder with pipe.
- Apply a protective plug to end of pipe.
- Clean mating surfaces in bell housing and check leakage from transmission if necessary.
Replacing seal: Transmission, input shaft seal, replacement .