Remove Left-Hand Driveshaft

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Gimmy Bar

Courtesy of VOLVO CARS OF NORTH AMERICA.

Twist MacPherson strut and pull out. Tap driveshaft end with plastic or copper mallet and pull driveshaft end out of hub.
Remove driveshaft from transmission. Use gimmy bar 9995462 between transmission and inside of drive shaft. See workshop guide bulletin/tool bulletin.

CAUTION: Treat driveshaft seals and bellows (gaiters) with care.

Install plug

9995488

Clean spline assembly (hub-driveshaft) of metal glue.