Removing the Clutch Cylinder
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Remove the rubber seal from the clutch cover. Move it inwards on the pipe towards the clutch cylinder.
Pull out the locking bracket that locks the quick-release connector on the pipe to the junction. The locking bracket sits on the outside of the clutch cover.
Remove the junction: Install a protective plug in the end of the pipe.
Remove the two screws holding clutch cylinder. Remove the cylinder.
Clean the mating surfaces in the clutch cover. Check any leakage from the transmission.
NOTE:
To replace the primary shaft seal on gasoline engines, see Replacing the Primary Shaft Seal . To replace the primary shaft seal on diesel engines, see Replacing the Primary Shaft Seal .