Install Clutch
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Install centering tool.
Use centering tool: 9995663 , changed according to: Workshop Guide no. 213, with conversion kit: 9989742 .
- Remove black cone from centering drift.
- Install centering drift in crankshaft center.
- Press in as far as possible.
- Use a wrench as a counterhold and then tighten the outer socket until the tool expander locks centering drift.
Make sure that centering drift is secure in crankshaft.
Install clutch.
- Check that clutch automatic adjustment is secured with counterhold: 9995677 .
- Install clutch and locate guide pins.
Press tool center screw is hollow so the centering drift can be installed.
- Check that clutch is in contact with the flywheel all around its circumference.
- Carefully tighten 6 screws crosswise so that clutch is guided onto the guide pins and is in contact with flywheel all the way round its circumference.
- Tighten screws. crosswise with 25 Nm .