Section 1 (4.2L - Engine Mechanical, Engine Code(S): BVJ)
WARNING: This page is about a different car, the 2010 Audi A8, 2009 Audi A8, 2008 Audi A8, and 2007 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.
- 00 - General, Technical Data
- 10 - Engine - Assembly
- 13 - Engine - Crankshaft, Cylinder Block
- Cylinder block, belt pulley side
- Cylinder block, transmission side
- Crankshaft
- Piston and connecting rod
- 15 - Engine - Cylinder head, Valvetrain
- Cylinder head
- Chain drive
- Timing chain covers, assembly overview
- Left and right timing chain covers, removing and installing
- Timing chain lower cover, removing and installing
- Camshaft timing chain, assembly overview
- Camshaft timing chains, removing from camshafts
- Camshaft timing chain, removing and installing
- Timing mechanism drive chain, assembly overview
- Drive chain for timing mechanism, removing and installing
- Power take-off drive chain, assembly overview
- Power take-off drive chain, removing and installing
- Power take-off, assembly overview
- Power take-off seals, replacing
- Spur gear unit, removing and installing
- Valvetrain
- 17 - Engine - Lubrication
- Oil pump and lower part of oil pan
- Oil pan (upper section)
- Oil check valve, spray nozzle valve, oil filter housing, oil cooler, oil pressure switch
- Oil check valve and spray nozzle valve, assembly overview
- Oil check valve and spray nozzle valve, removing and installing
- Crankcase ventilation hose, removing and installing
- Oil filter housing, assembly overview
- Oil filter housing, removing and installing
- Oil cooler, removing and installing
- Oil Pressure Switch F1, removing and installing
- Oil pressure and oil pressure switch F1, checking
- Engine oil
- Oil level, checking
- 19 - Engine - Cooling system
- Cooling system
- Coolant pump, coolant thermostat, coolant pipes
- Coolant pump and coolant thermostat, assembly overview
- Coolant pump, removing and installing
- Map Controlled Engine Cooling Thermostat F265, removing and installing
- Coolant thermostat opening data
- Coolant pipes, assembly overview
- Engine Coolant Temperature (ECT) Sensor G62, removing and installing
- Front coolant line, removing and installing
- Rear coolant line, removing and installing
- Left coolant pipe, removing and installing
- Lower left coolant pipe, removing and installing
- Right coolant pipe, removing and installing
- Radiator and coolant fan
- 26 - Exhaust system, Emission controls
- Muffler
- Exhaust manifold
- Secondary air injection (AIR) system
- Principle and function
- Secondary air injection (AIR) system, assembly overview
- Secondary Air Injection (AIR) pump, removing and installing
- Combination valve for secondary air injection (AIR), checking function and for leaks
- Left combination valve for Secondary Air Injection, removing and installing
- Right combination valve for Secondary Air Injection, removing and installing