Map Controlled Engine Cooling Thermostat F265, removing and installing

WARNING: This page is about a different car, the 2010 Audi A8, 2009 Audi A8, 2008 Audi A8, and 2007 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Drain coolant → Cooling system, draining and filling .

GW00022129

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector - arrow - on Map Controlled Engine Cooling Thermostat F265.

NOTE:

Ignore - 1 -.

GW00018504

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove coolant hoses - 1 and 2 - from Map Controlled Engine Cooling Thermostat F265 and drain coolant.
Remove bolts - arrows - and remove Map Controlled Engine Cooling Thermostat F265.

Installing

Tightening torque → Coolant pump and coolant thermostat, assembly overview .

Installation is in reverse order of removal, note the following:

NOTE:

Replace sealing rings and O-rings.
Secure all hose connections using hose clamps appropriate for the model type .

Fill with coolant → Filling .