Guide frame tightening sequence
WARNING: This page is about a different car, the 2010 Audi A8, 2009 Audi A8, 2008 Audi A8, and 2007 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.
- Replace bolts - 1 to 20 -.
- Tighten bolts as follows:
- Tighten bolts - 1 to 10 - to 30 Nm.
- Tighten bolts - 11 to 20 - to 20 Nm.
- Tighten bolts - 1 to 10 - to 50 Nm.
- Tighten bolts - 11 to 20 - to 30 Nm.
- Tighten bolts - 1 to 10 - an additional 90° (1 /4 turn).
- Tighten bolts - 11 to 20 - an additional 90° (1 /4 turn).
- Tighten guide frame to cylinder block sealing surface bolts, - highlighted in illustration but not numbered -, in a diagonal sequence to 9 Nm.