Drive plate, removing and installing

WARNING: This page is about a different car, the 2010 Audi A8, 2009 Audi A8, 2008 Audi A8, and 2007 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

GW00017342

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Counter-holder tool 10 - 201

Removing

Engine or transmission removed.

GW00017922

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Insert counterhold tool 10 - 201 to loosen bolts.
Identify position of drive plate to crankshaft with a felt-tip pen for reinstallation.
Remove drive plate.
Remove shim from behind it.

Installing

Tightening torque → Drive plate, assembly overview .

Installation is in reverse order of removal, note the following:

NOTE:

Replace bolts which have been tightened to torque.

Install drive plate with shim.
Turn over counterhold tool 10 - 201 to tighten bolts.