Radial clearance of connecting rod, measuring
WARNING: This page is about a different car, the 2010 Audi A8, 2009 Audi A8, 2008 Audi A8, and 2007 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Plastigage
Work procedure
- Remove connecting rod bearing caps.
- Clean bearing caps and journals.
- Place Plastigage over entire width of bearing journal or into bearing shells.
- Install connecting rod bearing cap and tighten to 60 Nm. Do not turn crankshaft.
- Remove connecting rod bearing caps again.
- Compare width of Plastigage with measuring scale.
Radial clearance:
- New: 0.020 to 0.069 mm.
- Wear limit: 0.120 mm.
- Replace connecting rod bolts.