Section 171 (Steering Column, Steering Pump - Removal & Installation (Coupe))
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Steering
- Power Steering Pump, Replacing
- Steering Column/Shaft/Seal/Bearing/Joint, Replacing
- Steering column/shaft/seal/bearing/lower shaft joint, Replacing (Cars With SRS)
- Notes
- Removing the Steering Wheel
- Removing Steering Column Components
- Install:
- Install steering shaft boot
- Install steering column mounting and steering shaft
- Install steering column
- Center column in dashboard opening
- Install the contact reel and tighten to 2.5 Nm
- Install ignition switch interlock cable (certain variants)
- Install knee bolster (certain variants)
- Reset and lock contact reel
- Zero the contact reel
- Lock the contact reel in this position with the locking screw
- Install steering wheel
- Reconnect battery ground cable. Drive the car straight ahead. Check that steering wheel is in straight-ahead position
- When the steering wheel is straight:
- Switch off ignition
- Install steering wheel module
- Check function
- Final check
- Check any diagnostic trouble codes (DTCs)
- Steering column/shaft/seal/bearing/lower shaft universal joint, Replacing (Cars without SRS)
- Steering column/shaft/seal/bearing/lower shaft joint, Replacing (Cars With SRS)
- Steering Column, Replacing