Installing the power steering pump

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Power Steering Pump Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Place paper over the generator (GEN) as protection against oil.

Install:

the servo pump
the three mounting screws through the pulley. Tighten to 25 Nm
the stay at the rear edge of the power steering pump (applies only to diesel)
the return and pressure hose. Use a new O-ring on the pressure hose.

Remove the lock grip pliers from the return hose.