Section 7 (Idle Stop & Go (ISG) System - 1.6L (Except HEV))

• Description And Operation
  • Description
  • Operation
• Components And Components Location
  • Components Location
• Schematic Diagrams
  • Operation Condition For The ISG Function
    • Notes
    • Idle Stop (Idle → Stop) Condition
      • Common Condition: Neutral Status & Clutch Pedal Released
      • Common Condition: Neutral Status & Clutch Pedal Pressed
    • Idle Start (Stop → Start) Condition
    • Auto-starting (Stop → Start) Condition
      • Notes
      • Common Condition: Neutral Status & Clutch Pedal Released
• Battery Sensor
  • Description And Operation
    • Description
  • Repair Procedures
    • Removal
    • Installation
• Brake Booster Vacuum Pressure Sensor
  • Description And Operation
    • Description
  • Schematic Diagrams
    • Circuit Diagram
  • Repair Procedures
    • Inspection
• AGM Battery
  • Description And Operation
    • Description
      • [AGM Battery for ISG System]
  • Specifications
    • AGM70L-Din
      • Notes
      • [BCI Type]
      • [DIN Type]
      • [AGM DIN Type]
  • Repair Procedures
    • Removal
      • [Battery]
      • [Battery Tray]
    • Inspection
      • [Using the Ammeter]
      • [Using the Clamp type Ammeter]
      • Battery Load Tester
    • The Micro 570 Analyzer
      • Notes
      • Keypad
      • Battery Test Procedure
      • Charging System Test Results
      • The MDX-670P Analyzer
    • Cleaning
    • Installation
      • Notes
      • [AGM Battery Charging]
      • IU or WU Charging Method
• DC-DC Converter
  • Description And Operation
    • Description
    • Operation
      • [Normal Driving]
  • Components And Components Location
    • Component Location
  • Schematic Diagrams
    • Circuit Diagram
      • [200W]
      • [450W]
  • Repair Procedures
    • Inspection
    • Removal
      • [200W]/[450W]
• ISG OFF Switch
  • Description & Operation
    • Description
  • Repair Procedures
    • Inspection
    • Removal
    • Installation
• Alternator
  • Description And Operation
    • Description
  • Specifications
    • Specification
  • Schematic Diagrams
  • Repair Procedures
    • Removal
    • Installation
    • Disassembly and Reassembly
    • Inspection
      • [Rotor]
      • [Stator]
• Starter
  • Description And Operation
    • Description
  • Specifications
    • Specification
  • Components And Components Location
    • Component
  • Schematic Diagrams
    • Circuit Diagram
  • Repair Procedures
    • Removal
    • Installation
    • Disassembly
    • Reassembly
    • Inspection
      • Armature Inspection and Test
      • Inspect Starter Brush
      • Starter Brush Holder Test
      • Inspect Overrunning Clutch
    • Cleaning
• Brake Switch
  • Description And Operation
    • Description
  • Repair Procedures
    • Adjustment
    • Inspection
      • Fuse Inspection
      • Diagnostic tool Data Analysis
      • Inspection Of Connector By Each Part
        • Notes
        • [Engine Room Junction Box]
        • [ABS/VDC Control Module]
      • Inspect The Stop Lamp Circuit
        • Notes
        • [Stop Lamp Switch Input/Output]
        • [Oscilloscope Waveform Screen]
    • Removal
    • Installation
• Door Switch
  • Description And Operation
    • Description
  • Repair Procedures
    • Inspection
      • Front Door Lock Module Inspection
      • Rear Door Lock Module Inspection
      • Trunk Lock Module Inspection
• Seat Belt Switch
  • Description And Operation
    • Description
  • Repair Procedures
    • Inspection
    • Removal
    • Installation
• Hood Switch
  • Description And Operation
    • Description
  • Repair Procedures
    • Inspection