Section 200 (Engine Mechanical - 1.4L (LDD, LDU, LUH, Or LUJ) - Repair Instructions - Off Vehicle (2 Of 2))
WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft and Bearing Cleaning and Inspection
- Engine Front Cover and Oil Pump Cleaning and Inspection
- Engine Front Cover and Oil Pump Disassemble
- Turbocharger Disassemble
- Turbocharger Cleaning and Inspection
- Turbocharger Assemble
- Engine Oil Cooler Disassemble
- Engine Oil Cooler Assemble
- Oil Pan Cleaning and Inspection
- Crankshaft and Bearing Installation
- Piston, Connecting Rod, and Bearing Installation
- Cylinder Head Installation
- Hydraulic Valve Lash Adjuster Installation
- Hydraulic Valve Lash Adjuster Arm Installation
- Intake Camshaft Installation
- Exhaust Camshaft Installation
- Camshaft Sprocket Installation
- Timing Chain Tensioner Installation
- Engine Front Cover Gasket Installation
- Camshaft Timing Chain Installation
- Engine Front Cover and Oil Pump Installation
- Oil Pan Installation
- Engine Oil Heater Installation
- Camshaft Position Actuator Solenoid Valve Installation
- Camshaft Cover Installation
- Ignition Coil Installation
- Engine Flywheel Installation (1.4L LUH and LUJ)
- Generator Installation
- Starter Installation
- Intake Manifold Installation (1.4L LUH and LUJ)
- Throttle Body Installation (1.4L LUH and LUJ)
- Water Pump Installation
- Crankshaft Balancer Installation
- Water Pump Pulley Installation
- Air Conditioning Compressor Bracket Installation
- Drive Belt Tensioner Installation
- Drive Belt Installation
- Engine Oil Cooler Installation
- Water Outlet Installation (1.4L LUH and LUJ)
- Engine Coolant Thermostat Housing Installation (1.4L LUH and LUJ)
- Turbocharger Installation
- Exhaust Manifold Heat Shield Installation (1.4L LUH and LUJ)
- Warm Up Three-Way Catalytic Converter Installation (1.4L LUH and LUJ)
- Positive Crankcase Ventilation Pipe Installation
- Engine Mount Bracket Installation
- Engine Front Cover and Oil Pump Assemble
- Drive Belt Removal
- Automatic Transmission Flex Plate Removal
- Engine Block Cleaning and Inspection
- Automatic Transmission Flex Plate Installation