LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Engine Mechanical - 1.4L (LDD, LDU, LUH, Or LUJ) - Repair Instructions - Off Vehicle (2 Of 2)) >> Turbocharger Assemble

Turbocharger Assemble

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Quick Fitting Connector And Seal Ring
    GM2192345Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the NEW quick fitting connector (2) and a NEW seal ring (1) to the turbocharger and tighten to 20 N.m (15 lb ft).
    2. Fig 2: Turbocharger Coolant Feed Pipe And Quick Fitting Connector
    GM2192343Courtesy of GENERAL MOTORS CORP.
  2. Inspect the turbocharger coolant pipes for ridges and damage.
  3. Install the turbocharger coolant feed pipe (1) to the quick fitting connector (2) by pushing in direction of the arrow until an audible click is heard.
  4. Use the same procedure for the turbocharger coolant return pipe and the turbocharger coolant return pipe quick fitting connector.
    5. Fig 3: Turbocharger Oil Return Pipe
    GM2191928Courtesy of GENERAL MOTORS CORP.
  5. Install the turbocharger oil return pipe (1) and a NEW sealing (3) to the turbocharger.
  6. Install the 2 turbocharger oil return pipe bolts (2) and tighten to 8 N.m (71 lb in).
scientia non olet · About LEMON Manuals