Drive Belt Installation

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

EN-955-2: Locking Pin
EN-48488: Holding Wrench

For equivalent regional tools, refer to Special Tools .

NOTE: Ensure that the drive belt tensioner is held with EN-955-2: locking pin.

Install the drive belt.

Fig 1: Locking Pin And Wrench

Courtesy of GENERAL MOTORS CORP.

Move the drive belt tensioner clockwise until EN-955-2: locking pin (2) can be removed. Use EN-48488: wrench (1).
Remove EN-955-2: locking pin (2) from the drive belt tensioner while holding with EN-48488: wrench (1).
Release tension from drive belt tensioner and remove EN-48488: wrench (1).