LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Engine Mechanical - 1.4L (LDD, LDU, LUH, Or LUJ) - Repair Instructions - Off Vehicle (2 Of 2)) >> Crankshaft and Bearing Cleaning and Inspection >> Crankshaft End Play, Check

Crankshaft End Play, Check

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Gauge Tool
    GM2190913Courtesy of GENERAL MOTORS CORP.
    NOTE: Crankshaft attached with crankshaft bearing caps.
  1. Install the GE-571-B:  gauge (1).
    • Install the holder on the front of the engine block.
    • Place the dial gauge plunger against the crankshaft and adjust.
  2. Measure the longitudinal play of the crankshaft.
    • Move the crankshaft in the longitudinal direction.
    • Permissible crankshaft end play 0.100-0.202 mm (0.0039-0.0080 in).
  3. Remove the GE-571-B:  gauge.
scientia non olet · About LEMON Manuals