LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Engine Mechanical - 1.4L (LDD, LDU, LUH, Or LUJ) - Repair Instructions - Off Vehicle (2 Of 2)) >> Engine Front Cover and Oil Pump Installation >> Camshaft Sprocket Fastening

Camshaft Sprocket Fastening

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Intake Camshaft Sprocket Gearing And Special Tool
    GM2190710Courtesy of GENERAL MOTORS CORP.
    NOTE: Push the fixing tool in the direction of the arrow to ensure it fully engages.
  1. Install EN-49977-200:  fixing tool (2) and ensure that the gearing of the fixing tool engages with the intake camshaft sprocket gearing (1).
    2. Fig 2: Adjuster Bolt And Fastening Bolts
    GM2190712Courtesy of GENERAL MOTORS CORP.
  2. Tighten the 2 fastening bolts (1) of EN-49977-200:  fixing tool while pushing the fixing tool in direction of the arrow.
  3. Tighten the adjuster bolt (2).
    4. Fig 3: Fastening Bolts And Fixation
    GM2190709Courtesy of GENERAL MOTORS CORP.
    NOTE: A wrong installation position is possible. Make sure that the holding tool is fully installed to the cylinder head in areas (3) and (5).
  4. Install EN-49977-100:  transmitter disc holder (2) to find and hold the correct position of the camshaft position exciter wheels.
  5. Tighten the fastening bolts (6) of EN-49977-100:  transmitter disc holder.
    6. CAUTION: Refer to Fastener Caution .
  6. Tighten the intake camshaft sprocket bolt (4) while holding the hexagon (1) of the intake camshaft to 50 N.m (37 lb ft).
  7. Tighten the intake camshaft sprocket bolt (4) while holding the hexagon (1) of the intake camshaft to an additional 60°.
  8. Tighten the exhaust camshaft sprocket bolt while holding the hexagon of the exhaust camshaft to 50 N.m (37 lb ft).
  9. Tighten the exhaust camshaft sprocket bolt while holding the hexagon of the exhaust camshaft to an additional 60°.
  10. Remove EN-49977-100:  transmitter disc holder and EN-49977-200:  fixing tool.
scientia non olet · About LEMON Manuals