Camshaft Cover Installation

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

Clean the sealing surfaces.

Fig 1: Sealing Compound Application Areas

Courtesy of GENERAL MOTORS CORP.

NOTE: The thickness of the sealing bead should be 2 mm (0.0787 in).

Apply sealing compound to areas (1) and (2). Refer to Adhesives, Fluids, Lubricants, and Sealers .

Fig 2: Camshaft Cover And Gasket

Courtesy of GENERAL MOTORS CORP.

NOTE: The installation procedure should not take longer than 10 minutes.

Install the camshaft cover (2) and a NEW gasket (3).
Install the 15 camshaft cover bolts (1).

Fig 3: Camshaft Cover Bolts Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Tighten the 15 camshaft cover bolts in a sequence as shown to 8 N.m (71 lb in).

Fig 4: Engine Oil Level Indicator

Courtesy of GENERAL MOTORS CORP.

Install the oil level indicator (1).