Special Tools

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

EN-6009: Remover and Installer Ignition Module

For equivalent regional tools, refer to Special Tools .

Fig 1: Ignition Coil And Remover And Installer

Courtesy of GENERAL MOTORS CORP.

Install the ignition coil (1) and remove EN-6009: remover and installer (2).

Fig 2: Ignition Coil Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the 2 ignition coil bolts (1) and tighten to 8 N.m (71 lb in).