Engine Flywheel Installation (1.4L LUH and LUJ)

Special Tools

• EN-470-B:  Angular Torque Wrench
• EN-652:  Flywheel Holder

For equivalent regional tools, refer to Special Tools .

Fig 1: Engine Flywheel And Bolts
Courtesy of GENERAL MOTORS CORP.
1. Install the engine flywheel (1).
2. Install the 6 engine flywheel bolts (2).
Fig 2: Engine Flywheel And Holder
Courtesy of GENERAL MOTORS CORP.
3. Install EN-652:  holder (1) to hold the engine flywheel (2).
CAUTION: Refer to Fastener Caution .
4. Tighten the 6 engine flywheel bolts in a cross sequence to 60 N.m (44 lb ft).
   1. Tighten the 6 engine flywheel bolts in a cross sequence to an additional 45° .Use EN-470-B:  wrench .
   2. Tighten the 6 engine flywheel bolts in a cross sequence to an additional 15° .Use EN-470-B:  wrench .
5. Remove EN-652:  holder.