Special Tool

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

EN-49940: Remover Quick Connector

For equivalent regional tools, refer to Special Tools .

Fig 1: Turbocharger Oil Return Pipe

Courtesy of GENERAL MOTORS CORP.

Remove the 2 turbocharger oil return pipe bolts (2).
Remove the turbocharger oil return pipe (1) and the sealing (3) from the turbocharger.

Fig 2: Turbocharger Coolant Feed Pipe

Courtesy of GENERAL MOTORS CORP.

NOTE: The quick fitting connectors should be always replaced when the turbocharger coolant pipes are removed

Install the EN-49940: remover (2) to the turbocharger coolant feed pipe (1) and the quick fitting connector as shown.
Compress the EN-49940: remover and remove the turbocharger coolant feed pipe direction of the arrow.

Fig 3: Quick Fitting Connector And Seal Ring

Courtesy of GENERAL MOTORS CORP.

Remove the quick fitting connector (2) and the seal ring (1).
Use the same procedure for the turbocharger coolant return pipe and the turbocharger coolant return pipe quick fitting connector.