Warm Up Three-Way Catalytic Converter Installation (1.4L LUH and LUJ)

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Catalytic Converter Components

Courtesy of GENERAL MOTORS CORP.

Install the warm up three way catalytic converter (5) to the brackets and the turbocharger. Use a NEW warm up three way catalytic converter seal (2).

NOTE: Never re-use the V-clamp.

Install a NEW warm up three way catalytic converter V-clamp (1).
Install the 2 catalytic converter to catalytic converter bracket nuts (4) and (6) and hand tighten.
Hand tighten the catalytic converter V-clamp.
Connect the heated oxygen sensor wiring harness (3) to retainer clip.

Fig 2: Catalytic Converter V-Clamp

Courtesy of GENERAL MOTORS CORP.

The catalytic converter V-clamp (1) should be installed in the shown position.

CAUTION: Refer to Fastener Caution .

Tighten the catalytic converter to catalytic converter bracket nuts to 22 N.m (16 lb ft).
Tighten the catalytic converter V-clamp to 13 N.m (115 lb in).