Section 31 (Controls, Housing - Manual Transmission 0A4 (Sedan) (A5 Platform))

• 34 Controls, Housing
  • General Information
    • Transmission Fluid, Checking And Filling
      • Notes
      • Secure The Gear Shift Unit Shift Shaft As Follows:
  • Description And Operation
    • Shift Mechanism, Adjusting
      • Notes
      • Function
    • Shift And Selector Cables, Installed Position
    • Shift Mechanism Overviews
      • Notes
      • Shift Knob And Boot
      • Shift Lever And Housing, Through 10.06
        • Notes
        • Selector Cable And Shift Cable, Removing And Installing
        • Lock Washer, Removing And Installing
        • Pressure Spring, Installing
      • Shift Lever And Housing, From 11.06
      • Shift And Selector Cables
        • Notes
        • Cable Retainer Allocation
        • As Of 02.06, Smaller Pin Diameter For The Shift Cable Retainer
        • Selector Lever/Relay Lever, Installed Position
        • Cable Tie, Installed Location
    • Transmission Gears Overview
    • Transmission Component Overviews
      • Notes
      • Transmission Housing And 5TH Gear Cover
      • Transmission Housing And Shift Mechanism
      • Input Shaft, Output Shafts, Differential And Shift Forks
  • Specifications
    • Fastener Tightening Specifications
  • Removal And Installation
    • Shift Knob, Boot And Noise Insulation
    • Plastic Relay Lever
      • Notes
      • Removing The Selector Cable Retainer From A Plastic Relay Lever
      • Installing The Cable Retainer
    • Shift Mechanism
    • Shift Cable And Selector Cable
    • Transmission, Transporting
    • Transmission
      • Removing
      • Installing
      • Tightening Specifications
    • Transmission Housing Cover And 5TH Gear
      • Notes
      • Removing Just The 5TH Gear
      • Engage 5TH Gear
  • Disassembly And Assembly
    • Shift Mechanism, From 11.06
    • Transmission
      • Notes
      • 5TH Gear, Installing
        • Notes
        • Installed Position, 5TH Gear
        • 5TH Gear Synchronizer Ring, Checking
        • 5TH Gear Synchronizer Ring With Cast Locking Pieces
        • Installed Position Of Plate Springs For 5TH Gear Synchronizer Hub And Drive Gear Bolts
        • Adjusting 5TH Gear
    • Transmission Housing And Clutch Housing
      • Notes
      • Removing The Needle Bearing
      • Installing The Needle Bearing
      • Removing The Seal From The Guide Sleeve
      • Installing The Seal All The Way Into The Guide Sleeve
      • Prying Out The Sleeve -Arrow-
      • Installing The Sleeve
      • Removing The Sleeve And Seal
      • Installing The Sleeve And Seal
      • Installing The Oil Catch Tray Into The Transmission
    • Shift Unit
      • Notes
      • Removing The Locking Pin -A- From The Shift Cover
      • Pressing The Locking Pin -A- Into The Shift Cover
      • Installing The Seal
    • Shift Forks
      • Notes
      • Shift Segment Identification
      • Removing The Lock Washer
      • Installing The Lock Washer
      • Removing The Angular Contact Ball Bearing
      • Installing The Angular Contact Ball Bearing Inner Race -A- Into The Outer Race
      • Installing The Angular Contact Ball Bearing Into The Shift Fork
  • Special Tools