Shift Lever And Housing, Through 10.06: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Lubricate the bearing areas and the sliding surfaces.
- Lock Washer
- Removing and installing, refer to LOCK WASHER, REMOVING AND INSTALLING .
- Bushing
- Pressure Spring
- Bushing
- Bolt
- 5 Nm
- Cover
- Sound Insulation
- Bearing Shell
- Bearing Shell
- Shift Lever Guide
- Washer
- Gasket
- Between the shift housing and the underbody.
- Self-adhesive.
- Affix to the shift housing.
- Shift Lever
- Shift Housing
- Bushing
- Pin
- Bushing
- Pressure Spring
- Installing, refer to PRESSURE SPRING, INSTALLING .
- Selector Bracket
- Bolt
- 5 Nm
- Gasket
- Always replace.
- Base Plate
- Bend the tabs in order to remove.
- Always replace.
- Selector Cable
- To the selector bracket.
- Removing and installing, refer to SELECTOR CABLE AND SHIFT CABLE, REMOVING AND INSTALLING .
- Shift Cable
- Removing from, and installing to the shift lever guide, refer to SELECTOR CABLE AND SHIFT CABLE, REMOVING AND INSTALLING .
- Lock Washer
- Always replace.
- Nut
- M8: 25 Nm
- M6: 8 Nm
- Quantity: 4
- Bushing
- Fits in one position only
- Lock Washer
- Always replace.