Installing The Angular Contact Ball Bearing Into The Shift Fork

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Angular Contact Ball Bearing Pulled Into Selector Fork Up To Limit Stop

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The depression inside the 3290/1 faces the ball bearing.

Fig 2: Identifying Allocation Shift Fork (Dimension)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

	Dimension -a- (mm)
1st/2nd gear selector fork	87.2 to 87.4
3rd/4th gear selector fork	93.6 to 93.8

Shift segment allocation, refer to SHIFT SEGMENT IDENTIFICATION .