Transmission Housing And Shift Mechanism
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 25 Nm
- Flange Shaft with Pressure Spring
- Removing and installing, refer to one of the following:
- Assembling, refer to DIFFERENTIAL .
- Bolt
- 25 Nm
- For the reverse shaft support.
- Self locking.
- Always replace.
- Bolt
- 30 Nm
- For the reverse shaft support.
- Self locking
- Always replace.
- O-ring
- Always replace
- Pivot Pin
- Bolt
- 25 Nm
- Bolt
- 25 Nm
- Sealing Cap
- Bolt
- 25 Nm
- For the reverse shaft support.
- Always replace.
- Bolt
- 5 Nm
- Transmission Neutral Position Sensor -G701-
- For vehicles with the start/stop system.
- Transmission Housing
- Remove together with 5th gear, refer to TRANSMISSION .
- Disassembling and assembling, refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .
- Clutch Housing
- Disassembling and assembling, refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .
- Bolt
- 25 Nm + 90° (1/4) additional turn.
- Always replace.
- Selector Lever with Selector Cover
- (Shift unit)
- Disassembling and Assembling, refer to SHIFT UNIT .
- Bolt
- 25 Nm