Shift Lever And Housing, From 11.06
WARNING: This page is about a different variant/trim than selected.
NOTE:
Lubricate the bearing areas and the sliding surfaces.
Shift mechanism, disassembling and assembling. Refer to SHIFT MECHANISM, FROM 11.06 .
- Base Plate
- Bend the tabs in order to remove.
- Always replace.
- Gasket
- Always replace.
- Shift Lever
- Can be removed and installed with the shift lever guide -item 15- installed.
- Washer
- Slide out of shift lever as far as stop -arrow-.
- Lock Washer
- Be careful not to damage the cables when removing them.
- Always replace.
- Selector Cable
- Pry off of the selector bracket.
- Press onto the selector bracket inside the shift housing.
- Installed position, refer to SHIFT AND SELECTOR CABLES, INSTALLED POSITION .
- Bushing
- Shift Cable
- Pry off of the shift lever guide.
- Press onto the shift lever guide inside the shift housing.
- Installed position, refer to SHIFT AND SELECTOR CABLES, INSTALLED POSITION .
- Sound Insulation
- Bearing Shell
- Will get damaged when being removed.
- Always replace.
- Bushing
- Lock Washer
- Removing and installing, refer to LOCK WASHER, REMOVING AND INSTALLING .
- Pressure Spring
- Installing, refer to PRESSURE SPRING, INSTALLING .
- Bushing
- Shift Lever Guide
- Nut
- M8: 25 Nm
- M6: 8 Nm
- Quantity: 4
- Gasket
- Between the shift housing and the underbody.
- Self-adhesive.
- Affix to the shift housing.
- Shift Housing
- With pressure spring and selector bracket.
- Pressure spring and selector bracket cannot be removed.