Section 18 (General Information - Body)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
- Safety instructions
- Safety instructions for raising vehicles
- Safety instructions for welding
- Safety instructions for flying sparks during grinding and welding work
- Safety instructions for fuel tank
- Safety instructions for air conditioning
- Safety instructions for sticking
- Safety instructions for installation work
- Safety instructions for corrosion protection
- General information and quality notes
- Tools and metalworking tools for body repairs
- Check dimensions for body repair
- Body parts of high-strength steel
- Diagram of safety passenger compartment
- Water drainage
- Plug location plan
- Gap dimensions, body
- Diagram - keys to symbols for welding work
- Undersealing
- Seam seals
- Unpainted body shell
- Top of front of vehicle
- Top of front of vehicle, front
- Top of front of vehicle, (radiator tank)
- Front of vehicle and inside A-pillars
- Front of vehicle and outside A-pillars
- Side of front of vehicle
- Top of inside front of vehicle and floor
- Top of lower side member and floor
- Wheel housing and upper rear side section
- Engine compartment
- Top of rear end
- Bottom of rear end
- Side of rear end
- Tools and materials
- Work sequence for accident repair
- Work sequence for determining scope of damaged vehicles involved in an accident
- Vehicle identification number
- Change identification data plate