Section 29 (Crankshaft & Cylinder Block (General & Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA))

• 13 Crankshaft, Cylinder Block
  • Cylinder Block, Belt Pulley Side
    • Overview - Cylinder Block, Belt Pulley Side
      • Notes
      • Accessory Assembly Bracket Tightening Specifications And Sequence
    • Overview - Belt Pulley Side Sealing Flange
      • Notes
      • Tightening Specifications
    • Ribbed Belt, Removing And Installing
      • Notes
      • Removing
      • Installing
      • Tightening Specifications
    • Ribbed Belt TENSIONER, Removing And Installing
      • Removing
      • Installing
      • Tightening Specifications
    • Vibration Damper, Removing And Installing
      • Removing
      • Installing
      • Tightening Specifications
    • Sub-Assembly Bracket, Removing And Installing
      • Removing
      • Installing
      • Tightening Specifications
    • Engine Support, Removing And Installing
      • Removing
      • Installing
      • Tightening Specifications
    • Sealing Flange, Removing And Installing, Belt Pulley Side
      • Notes
      • Removing
      • Installing
      • Tightening Specifications
  • Cylinder Block, Transmission Side
    • Overview - Cylinder Block, Transmission Side
      • Notes
      • Installing Intermediate Flange
      • Transmission Side Side Sealing Flange Tightening Specifications And Sequence
    • Flywheel, Removing And Installing
      • Notes
      • Removing
      • Installing
      • Tightening Specifications
    • Sealing Flange, Removing And Installing, Transmission Side
      • Notes
      • Sealing Flange With Sensor Wheel, Removing
      • Sealing Flange With Sensor Wheel, Installing
      • Locating Pin
      • Guide Pin For Diesel Engines (Black Handle)
      • Sensor Wheel Installation Position On Crankshaft, Checking
      • Sensor Wheel, Pressing On
      • Assembling
      • Tightening Specifications
  • Crankshaft
    • Overview - Crankshaft
    • Crankshaft Dimensions
    • Crankshaft Needle Bearing, Replacing
      • Notes
      • Needle Bearing, Removing
      • Needle Bearing, Installing
    • Crankshaft, Measuring Axial Clearance
      • Notes
      • Procedure
  • Pistons And Connecting Rod
    • Overview - Pistons And Connecting Rod
      • Notes
      • Piston Installed Location And Allocation, Piston To Cylinder
      • Installed Position Of Bearing Shell
      • Tightening Specification For Oil Spray Jet And Relief Valve
    • Pistons, Removing And Installing
      • Notes
      • Removing
      • Installing
      • Tightening Specifications
    • Piston Projection, Measuring At TDC
      • Notes
      • Procedure
    • Piston And Cylinder Bore, Checking
      • Notes
      • Checking The Piston Ring Gap
      • Checking The Piston Ring Groove Clearance
    • New Connecting Rod, Disconnecting
      • Clamping Connection Rod With Vise
    • Connecting Rods, Checking Radial Clearance
      • Notes
      • Procedure
    • Oil Spray Jets, Removing And Installing
      • Notes
      • Removing
      • Installing
      • Tightening Specifications
  • Special Tools