Piston Projection, Measuring At TDC: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Measuring Bar :VW382/7 from the Special Socket & Measuring Tools :VW382
- Measuring Set - Magnetic Plate - 50mm :VW385/17 from Measuring Set :VW385
- Dial Indicator - 0-10mm :VAS6079
NOTE:
Check the piston projection at "TDC" whenever installing a new piston or part of the engine.
If different values occur when measuring the piston projection, use the highest value for cylinder head gasket allocation.
Depending on the piston projection, install the corresponding cylinder head gasket according to the following table.