Oil Spray Jets, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
CAUTION:
Risk of damaging the oil spray jets.
- Do not bend the oil spray jets.
- Check the oil spray jet clearance after reinstalling the pins.
- Bent oil spray jets must be replaced.
-- Align the guiding edge of the oil spray jet to the machined surface of the cylinder block.
-- Install the oil pan. Refer to OIL PAN, REMOVING AND INSTALLING .
-- Install the noise insulation. Refer to NOISE INSULATION .