LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Crankshaft & Cylinder Block (General & Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Sub-Assembly Bracket, Removing And Installing >> Installing

Sub-Assembly Bracket, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Check if an alignment sleeve is between the sub-assembly bracket and the cylinder block.

scientia non olet · About LEMON Manuals