Accessory Assembly Bracket Tightening Specifications And Sequence

WARNING: This page is about a different variant/trim than selected.

Fig 1: Accessory Assembly Bracket Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Install the bolts as follows:

-- Tighten the bolts in the steps shown in the sequence:

Step	Bolts	Tightening Specification/Additional Turn
1	-1 to 6-	Install by hand all the way
2	-1 to 6-	40 Nm
3	-4 and 5-	180° additional turn
4	-1, 2, 3 and 6-	45° additional turn