Pistons, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
NOTE:
Replace the bolts that were tightened with an additional turn.
-- Coat the contact surfaces on the bearing shells with oil.
-- Install the piston with the piston ring compressor.
Installation Position:
- Piston. Refer to Piston Installed Location And Allocation, Piston To Cylinder .
- Bearing shells in the connecting rod. Refer to Installed Position Of Bearing Shell .
-- Install the connecting rod bearing cap according to the marking.
-- Install the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING .
-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .