Engine Support, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

-- Install the bolt -2- before installing the engine support in the engine support hole.

-- Mount the engine support and tighten the bolts -1 through 3- hand-tight.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts as follows to the specified tightening specification and sequence. Refer to the figure below;

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the upper toothed belt guard. Refer to TOOTHED BELT GUARD, REMOVING AND INSTALLING .

-- Install the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .