Section 90 (Lane Departure Warning System (LDWS) - With Diagnostics)
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Special Tools
- Diagnosis Function
- Check Of Freeze Frame Data
- Indicator Light Or Warning Light List
- Diagnostic Trouble Code Table
- Diagnostic Trouble Code Procedures
- DTC C1702: LDW CAMERA fail
- DTC C1703: LDW CAMERA not Initialization
- DTC C1704: LDW CAMERA high temperature
- DTC C1705: LDW SW circuit low (short)
- DTC C1706: LDW CAMERA adjustment Not COMP
- DTC C1707: Implausible coding data
- DTC B1950: Rain sensor error; DTC B1951: Light sensor error
- DTC B1952: Rain sensor initialize error
- DTC B2507: Steering angle sensor defective
- DTC U0121: ABS/ASC CAN timeout
- DTC U0126: SAS CAN timeout
- DTC U0141: ETACS CAN timeout
- DTC U1190: No receive fault detect signal
- DTC U1195: Coding not completed
- DTC U15A2: Vehicle speed information lost
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Cannot communicate with LDW-ECU using the scan tool (M.U.T.-III)
- Inspection Procedure 2: The system is not turned on and off by operating the LDW switch
- Inspection Procedure 3: The LDW does not enter the warning monitor mode under some circumstances
- Inspection Procedure 4: The LDW is cancelled together with a visual warning temporarily
- Data List Reference Table
- Monitor items by the LDW-ECU
- Actuator Test Table
- Check At LDW-Ecu Terminal
- On-Vehicle Service
- LDW-Ecu
- LDW Switch