Actuator Test Table
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
| Item No. | Item name | Test contents | Set value < Scan tool (M.U.T.-III) indication > |
|---|---|---|---|
| 1 | Vehicle Speed Off Set 65 Mode | Execute this actuator test to allow the system to enter the warning monitor status (standby mode) with the vehicle stationary. By doing this, a simulated vehicle speed of 65 km/h will be set within the set time. If the vehicle is driven under this condition, the simulated speed of 65 km/h will be added to an actual speed. | 1 min |
| 10 min | |||
| 30 min | |||
| 60 min | |||
| 2 | Standby request output | The icon in the combination meter should appear under the warning monitor status (standby mode). | V |
| 3 | Warning request output | The icon in the combination meter should appear under the warning status (WARNING L-LANE or WARNING R-LANE). | Warning R-lane |
| Warning L-lane | |||
| 4 | TEMP. fail request output | The icon in the combination meter should appear when the LDW precheck function is in progress, or the LDW is defective (excluding too hot LDW-ECU and an intermittent malfunction). | V |
| 5 | System fail request output | The icon in the combination meter should appear under the warning monitor status (standby mode). | V |