Monitor items by the LDW-ECU
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- These monitor items depend on the vehicle drive conditions (weather, night or day, lane condition) significantly. Therefore, concrete values cannot be determined. For this reason, only the check conditions and patterns of value variations will be explained as below:
| Item No. | Scan tool (M.U.T.-III) display | Scan tool (M.U.T.-III) display explanation | Check condition | Normal condition |
|---|---|---|---|---|
| 100 | Lane Approach Distance (R) | The scan tool displays a shortest distance between your vehicle and a lane line. | The vehicle is being driven on the road where a lane is clear. | Scan tool-displayed value decreases as the vehicle approaches a lane line. |
| 101 | Lane Approach Distance (L) | |||
| 102 | Lane Width | The scan tool displays a lane width (distance between lane lines). | The vehicle is being driven on the lane where lane lines are clear at both sides. | Scan tool-displayed value changes as a lane width (distance between lane lines) decreases or increases. |
| 130 | Calib.stat.: Camera internal data | The scan tool displays the initialization status of the LDW camera. | The initialization is complete successfully. | No problem dete. |
| The LDW-ECU has never been initialized since it was installed. | Not setup (Defa.) | |||
| The LDW-ECU cannot be initialized, because it is defective. | ECU inter. error | |||
| The LDW-ECU cannot be initialized, because the system is defective. | not defined | |||
| 133 | Calib.status: Image adjustment | The scan tool displays the image adjusting status of the LDW camera. | The adjustment is complete successfully. | No problem dete. |
| The image has never been adjusted since LDW-ECU was installed. | Not setup (Defa.) | |||
| The image cannot be adjusted, because LDW-ECU is defective. | ECU inter. error | |||
| The image cannot be adjusted, because the system is defective. | not defined | |||
| 134 | Calib.integ.: Camera inter. data | The scan tool displays how many times the LDW camera has been initialized. The scan tool value will return to "0" if the initialization of the LDW camera is reset. | - | Scan tool-displayed value depends on how many times the LDW camera has been initialized. |
| 137 | Calib.integ.: Image adjustment | The scan tool displays how many times the focus of the LDW camera image has been adjusted. The scan tool value will return to "0" if the image compensation value of the LDW camera is reset. | Scan tool-displayed value depends on how many times the focus of the LDW camera image has been adjusted. |