LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Lane Departure Warning System (LDWS) - With Diagnostics) >> LDW-Ecu >> Removal And Installation >> Installation Service Point >> >> A << LDW-Ecu Installation

>> A << LDW-Ecu Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the protection cap, which is installed on the LDW-ECU, carefully.
  2. Install the LDW-ECU to the LDW-ECU bracket. When attaching the LDW-ECU, be careful not to touch the mounting surface (silicone portion) and hold air bubbles. Just in case that fingerprints remain on the silicone portion, eliminate it using a plastic tape.
    NOTE: However, note that the silicone portion is vulnerable.
  3. Turn the first lever to the arrow direction.
    Fig 1: Identifying Protection Cap And LDW-ECU
    G09667376Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Turn the second lever to the arrow direction.
    Fig 2: Turning Second Lever
    G09667377Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals