How to reset the LDW camera image compensation value
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
If you adjust the LDW camera image again on the ECU which camera image has been adjusted before, first reset the image compensation image.
- Turn the ignition switch "OFF" and then connect the scan tool (M.U.T.-III) to the data link connector (For how to connect the scan tool (M.U.T.-III), refer to DIAGNOSIS FUNCTION ).
- Turn the ignition switch to the "ON" position. (Do not start the engine.)
- Select the scan tool (M.U.T.-III) screen menu as follows.
- Select "Lane Keep" displayed on the "System selection" screen.
- Select "Special function."
- Select "Reset."
- Select "Decalibration: Image adjustment."
- After the reset is complete, DTC No. C1706 will be stored and the LDW warning light in the combination meter will illuminate.