Data List Reference Table
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
| Item No. | Scan tool (M.U.T.-III) display | Check condition | Normal condition | |
|---|---|---|---|---|
| 1 | ECU power-supply voltage | Always | Battery positive voltage (9 to 16 V: LDW operable range) | |
| 10 | Vehicle speed | Perform a test run of the vehicle. | Speedometer displayed value and scan tool displayed value agree with each other. | |
| 11 | Yaw rate sensor | Vehicle stopped (level) | -3.6 to 3.6 deg/s | |
| Running | -100 to 100 deg/s | |||
| 12 | Steering angle sensor status | When the steering wheel sensor neutral point is learned. | Normal | |
| When the steering wheel sensor neutral point is not learned | No Initialize | |||
| The steering wheel sensor is defective. | Fail | |||
| The steering wheel sensor is defective and the steering wheel sensor neutral point is not learned. | No Ini. & Fail | |||
| 13 | Steering angle sensor | Vehicle stopped (the steering wheel is in the neutral position) | -6 to 6 deg | |
| Running | Nearly the same as the steering wheel operation angle <-720 to 720 deg (LDW-ECU normal detection value) > | |||
| 14 | Brake switch | The brake pedal is released. | OFF | |
| The brake pedal is depressed. | ON | |||
| 15 | IG/Electric motor switch | Ignition switch: ON | Running (ON) | |
| Ignition switch: START position | Start | |||
| 16 | Turn light left | The turn-signal lights (LH) go out. | OFF | |
| The turn-signal lights (LH) illuminate. | ON | |||
| 17 | Turn light right | The turn-signal lights (RH) go out. | OFF | |
| The turn-signal lights (RH) illuminate. | ON | |||
| 18 | LDW switch | When the LDW switch is not pressed. | OFF | |
| When the LDW switch is pressed. | ON | |||
| 19 | Rain sensor ON/OFF | The wiper switch is at a position other than AUTO. | OFF | |
| The wiper switch is at AUTO position. | ON | |||
| 20 | Wiper auto stop switch | The windshield wiper are operating. | Outside park | |
| Other than above | Park | |||
| 21 | Light sensor sensitivity | Changes from "1" to "5" according to the customization value stored in the LDW-ECU (light sensor). | Level1: Brighter | |
| Level2: Bright | ||||
| Level3: Default | ||||
| Level4: Dark | ||||
| Level5: Darker | ||||
| 22 | Rain sensor sensitivity | Changes from 1 to 5 according to the wiper volume. | Level1 (Lowest) | |
| Level2 (Low) | ||||
| Level3 (Mid) | ||||
| Level4 (High) | ||||
| Level5 (Highest) | ||||
| 23 | Light sensor setting | - | Europe | |
| 31 | Ambient temperature | - | The actual ambient temperature and the scan tool display almost agree with each other. | |
| 71 | LDW Status Request | Changes according to the LDW operation status. | - | SNA (Default) |
| Operation status: OFF | OFF | |||
| Operation status: ON | ON | |||
| In the warning monitor status (standby) | Standby | |||
| The warning on the right side of the vehicle is activated. | Warning R-lane | |||
| The warning on the left side of the vehicle is activated. | Warning L-lane | |||
| The LDW-ECU is too hot or an intermittent malfunction is present in a device connected to this system. | TEMP. fail | |||
| The LDW precheck function is in progress, or the LDW is defective (excluding too hot LDW-ECU and an intermittent malfunction) | System fail | |||
| 72 | LDW Mode Request | Always | ON mode | |
| 74 | Wiping stage | The LDW-ECU (rain sensor) does not request. | OFF | |
| The LDW-ECU (rain sensor) requests the LO stage. | Stage1 (Lo) | |||
| The LDW-ECU (rain sensor) requests the HI stage. | Stage2 (Hi) | |||
| 81 | Taillight | lighting switch: OFF | OFF | |
| lighting switch: TAIL | ON | |||
| 82 | Low beam | When headlights (low-beam) are off | OFF | |
| When low-beam headlights are on | ON | |||
| 83 | Tunnel detection | The vehicle is not being driven in a tunnel. | Not detected | |
| The vehicle is being driven in a tunnel. | Detected | |||
| 103 | Lane Detection (R) | The LDW is deactivated. Alternatively, the vehicle is being driven on the road where lane division lines are not clear with the LDW activated. | OFF (Default) | |
| The vehicle is being driven on the road where lane division lines are clear with the LDW activated. | ON | |||
| 104 | Lane Detection (L) | The LDW is deactivated. Alternatively, the vehicle is being driven on the road where lane division lines are not clear with the LDW activated. | OFF (Default) | |
| The vehicle is being driven on the road where lane division lines are clear with the LDW activated. | ON | |||
| 105 | Warning availability (R) | The vehicle is being driven on the middle (not near a lane line) of the road where lane division lines are clear | OFF (Default) | |
| The vehicle is being driven near or across a lane division line of the road. | ON | |||
| 106 | Warning availability (L) | The vehicle is being driven on the middle (not near a lane line) of the road where lane division lines are clear | OFF (Default) | |
| The vehicle is being driven near or across a lane division line of the road. | ON | |||
| 220 | Rain sensor measurement value | The LDW-ECU (rain sensor) detects raindrops. | Value changes when the LDW-ECU (rain sensor) detects rain drops. | |