Electronic Suspension System - Road Sensing Suspension

• Specifications
  • Fastener Tightening Specifications
• Schematic and Routing Diagrams
  • Suspension Controls Schematic Icons
  • Suspension Controls Schematics (Power and Ground)
• Component Locator
  • Suspension Controls Component Views
  • Suspension Controls Connector End Views
• Diagnostic Information and Procedures
  • Diagnostic Starting Point - Road Sensing Suspension
  • Diagnostic System Check - Road Sensing Suspension
    • Test Description
  • Scan Tool Output Controls
  • Scan Tool Data List
  • Scan Tool Data Definitions
    • Continuously Variable Road Sensing Suspension Scan Tool Data Definitions:
  • Diagnostic Trouble Code (DTC) List
  • DTC C0550: ECU Malfunction - Internal Write/Checksum Malfunction
    • Circuit Description
    • Conditions for Running the DTC
    • Conditions for Setting the DTC
    • Action Taken When the DTC Sets
    • Conditions for Clearing the MIL/DTC
    • Test Description
  • DTC C0563: Calibration ROM Checksum Error
    • Circuit Description
    • Conditions for Running the DTC
    • Conditions for Setting the DTC
    • Action Taken When the DTC Sets
    • Conditions for Clearing the MIL/DTC
    • Test Description
  • DTC C0577: LF Solenoid Circuit Low; C0578: LF Solenoid Circuit High; C0579: LF Solenoid Circuit Open; C0582: RF Solenoid Circuit Low; C0583: RF Solenoid Circuit High; C0584: RF Solenoid Circuit Open; C0587: LR Solenoid Circuit Low; C0588: LR Solenoid Circuit High; C0589: LR Solenoid Circuit Open; C0592: RR Solenoid/Motor/Actuator Circuit; C0593: RR Solenoid Circuit High; C0594: RR Solenoid Circuit Open
    • Circuit Description
    • DTC C0577, C0582, C0587, or C0592
    • DTC C0578, C0583, C0588, or C0593
    • DTC C0579, C0584, C0589, or C0594
    • Conditions for Running the DTC
      • DTC C0577, C0579, C0582, C0584, C0587, C0589, C0592, or C0594
      • DTC C0578, C0583, C0588, or C0593
    • Conditions for Setting the DTC
      • DTC C0577, C0582, C0587, or C0592
      • DTC C0578, C0583, C0588, or C0593
      • DTC C0579, C0584, C0589, or C0594
    • Action Taken When the DTC Sets
      • DTC C0578, C0579, C0583, C0584, C0588, C0589, C0593, or C0594
      • DTC C0577, C0582, C0587, or C0592
    • Conditions for Clearing the MIL/DTC
    • Diagnostic Aids
    • Test Description
  • DTC C0615: LF Position Sensor Malfunction; C0620: RF Position Sensor Malfunction; C0625: LR Position Sensor Malfunction; C0630: RR Position Sensor Malfunction
    • Circuit Description
    • Conditions for Running the DTC
    • Conditions for Setting the DTC
    • Action Taken When the DTC Sets
    • Conditions for Clearing the MIL/DTC
    • Diagnostic Aids
    • Test Description
  • DTC C0635: LF Normal Force Circuit Malfunction; C0638: LF Normal Force Circuit High; C0640: RF Normal Force Circuit Malfunction; C0643: RF Normal Force Circuit High; C1252: LF Normal Force Malfunction; C1253: RF Normal Force Malfunction
    • Circuit Description
    • Conditions for Running the DTC
    • Conditions for Setting the DTC
      • DTC C0635 or C0640
      • DTC C0638 or C0643
      • DTC C1252 or C1253
    • Action Taken When the DTC Sets
    • Conditions for Clearing the MIL/DTC
    • Diagnostic Aids
    • Test Description
  • DTC C0665: Chassis Pitch Signal Circuit
    • Circuit Description
    • Conditions for Running the DTC
    • Conditions for Setting the DTC
    • Action Taken When the DTC Sets
    • Conditions for Clearing the MIL/DTC
    • Diagnostic Aids
    • Test Description
  • DTC C0690: Damper Control Relay Circuit Malfunction; C0691: Damper Control Relay Circuit Range; C0693: Damper Control Relay Circuit High
    • Circuit Description
    • Conditions for Running the DTC
    • Conditions for Setting the DTC
      • DTC C0690
      • DTC C0691
      • DTC C0693
    • Action Taken When the DTC Sets
    • Conditions for Clearing the MIL/DTC
    • Diagnostic Aids
    • Test Description
  • DTC C0695: Position Sensor Overcurrent (8 Volt Supply)
    • Circuit Description
    • Conditions for Running the DTC
    • Conditions for Setting the DTC
    • Action Taken When the DTC Sets
    • Conditions for Clearing the MIL/DTC
    • Diagnostic Aids
    • Test Description
  • DTC C0710: Steering Position Signal Malfunction
    • Circuit Description
    • Conditions for Running the DTC
    • Conditions for Setting the DTC
    • Action Taken When the DTC Sets
    • Conditions for Clearing the MIL/DTC
    • Diagnostic Aids
    • Test Description
  • DTC C0896: Electronic Suspension Control (ESC) Voltage Is Outside The Normal Range Of 9-15.5 Volts
    • Circuit Description
    • Conditions for Running the DTC
    • Conditions for Setting the DTC
    • Action Taken When the DTC Sets
    • Conditions for Clearing the MIL/DTC
    • Diagnostic Aids
    • Test Description
• Repair Instructions
  • Electronic Suspension Control Module Replacement
    • Removal Procedure
    • Installation Procedure
  • Electronic Suspension Control Module Calibration
  • Front Position Sensor Replacement - Electronic Suspension
    • Removal Procedure
    • Installation Procedure
  • Rear Position Sensor Replacement - Electronic Suspension
    • Removal Procedure
    • Installation Procedure
• Description and Operation
  • Road Sensing Suspension Description and Operation
    • Notes
    • Continuously Variable Road Sensing Suspension (CVRSS) Module
    • Position Sensors
    • Shock Absorber or Strut
    • Vehicle Speed
    • Lift/Dive
    • Warning Messages
• Special Tools and Equipment