Section 1332 (Rear Axle - Repair -- Z4_E89)
WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
- General And Safety Information
- 00 Safety instructions for handling oil
- 33 00... Information on replacing shock absorbers
- 33 00... Instructions for chassis components made of aluminum
- 33 00... Notes on repairing threads
- 31 00... Notes on wheel bearing replacement following accident damage
- 00..... Raising vehicle with trolley jack
- 33... Rear axle layout
- 33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work
- 51 47 491 Removing and installing/replacing rear underbody protection
- 33... Grease for flange nut and drive flange
- Differential
- Drive Flange, Cover Gaskets, And Radial Shaft Seals
- 33 11 080 Replacing left/right drive flange on rear differential
- 33 11 021 Replacing radial shaft seal for drive flange on rear axle final drive
- 33 11 271 Replacing rear cover gasket on rear differential
- 33 11... Replacing rear cover gasket on rear differential (188L)
- 33 11... Replacing rear cover gasket on rear differential (215 with lock)
- 33 11... Replacing rear cover gasket on rear differential (215L)
- 33 11 140 Replacing shaft seal for left/right drive flange
- Differential Mounting
- Output Shafts
- 33 21... Notes on bolts with ribbed teeth
- 33 21... Pressing output shaft out of drive flange and drawing in (output shaft removed from rear axle final drive)
- 33 21 001 Removing and installing or replacing left output shaft
- 33 21 002 Removing and installing/replacing right output shaft
- 33 21 071 Replacing both gaiters on left and right of output shaft
- Rear Sub-Frame
- 33 31. Overview of rear axle carrier with rubber mounts
- 33 31 503 Lowering/raising rear axle support
- 33 31 000 Removing and installing complete rear axle support
- 51 71 390 Removing and installing/replacing reinforcement plate on rear axle
- 33 31 025 Removing and installing/replacing vibration absorber on side member
- 33 31 011 Replacing rear axle carrier
- Control Arms And Struts
- 33 32... Overview of control arms with rubber mounts
- 33 32 077 Removing and installing/replacing top right control arm
- 33 32 086 Removing and installing/replacing bottom left control arm
- 33 32 087 Removing and installing/replacing bottom right control arm
- 33 32 160 Removing and installing/replacing compression strut for rear axle carrier
- 51 71 482 Removing and installing/replacing left or right tension strut
- 33 32 076 Removing and installing/replacing top left control arm
- 33 32 024 Replacing a ball joint in trailing arm
- 33 32 681 Replacing a rubber mount in the lower wishbone (wishbone removed)
- 33 32 044 Replacing a rubber mount in trailing arm for bottom wishbone
- 33 32 042 Replacing a rubber mount in trailing arm, front
- 33 32... Replacing bearing support for front trailing arm
- 33 32 021 Replacing left or right trailing arm
- 33 32 671 Replacing one rubber mount in the upper control arm (control arm removed)
- Axle Mounting
- Wheel Bearings
- Shock Absorber
- Coil Springs
- Stabilizer Bar